Filter
Top Products
- 6 -
Troubleshooting
If the flame goes out during use, this could have
several grounds.
Attention:
In this case ALWAYS first place the regulator valve
into the position OFF and return the clamping valve
back into the start position 0! THEN attempt to
eliminate the cause!
Defect Cause Remedy
The flame
has gone
out.
The gas container
is empty
Install a new gas
container.
The protective
device in the
regulator valve
has activated, the
appliance is over-
heated.
Allow the appliance
to cool down suffi-
ciently and then
reignite it.
Wind has blown
the flame out
Wait until any dischar-
ged but unburnt gas
has evaporated and
then reignite it.
The burner head
has been soiled
by overflowing
foodstuffs
Allow the appliance
to cool down then
clean the burner head
as described in the
chapter "Cleaning
and Care".
The clam-
pling
lever
does not
engage.
The catchment
bowl is inserted
into the housing
laterally.
Assemble the catch-
ment bowl as descri-
bed in the section
"Commissioning".
Ending usage
• Check that burners are extinguished before
disconnecting the gas container.
• Place the regulator valve into the position OFF
and wait until the flame has gone out. Then return
the clamping valve back into the start position 0
and always remove the gas canister.
• Replace the protective cap back onto the gas
canister and then store it in a cool and dry location.
The storage temperature must always lie below
50°C.
Caution:
In cars and caravans and with sufficient intense sunlight,
very high temperatures can be generated!
• Place the regulator valve into the ignite position ,
so that the remaining gas in the gas cooker can
be burnt off.
• Place the regulator valve back into the position OFF.
• Store the gas cooker in the transport case in a dry,
cool and well ventilated location.
Cleaning and Care
The gas cooker should be cleaned regularly and after
every use.
• Clean the housing with a damp cloth and mild
detergent.
Do not submerse the appliance in water!
• The catchment bowl can be cleaned in dishwater.
Cleaning the burner head
• To dismantle the burner head, loosen the central
screw and then clean the gas exit openings with
a soft brush.
IB_KH4202_RP42311_LB3C 08.01.2009 9:50 Uhr Seite 6