Filter
Top Products
- 3 -
Information regarding the interaction
with gas canisters:
• Inflammable gas is under pressure.
Attention!
Do not refill!
• Protect it from direct sunlight and do not subject
it to temperatures exceeding 50° C.
• Store at a cool and dry location. Ensure that the
location is well ventilated.
• Dispose of the canister at a safe location.
• Even when it is empty, the canister may not be
punctured or burnt.
• Do not spray against flames or onto glowing objects.
• Keep it well away from ignitable sources - do not
smoke.
• Do not permit the canister to come into the
hands of children!
• This canister may only be used with the Butane
Gas Cooker KH 4202!
• Observe the operating instructions for the relevant
appliance!
• This canister conforms with Standard EN 417.
• Exchange gas canister in a well ventilated loca-
tion, preferably outside, away from any sources
of ignition, such as naked flames, pilots, electric
fires and away from other people.
Conduct in the event of a gas leak
If there is a strong smell of gas or you can hear gas
leaking, it will be coming from either the canister or
from the gas cooker. Should this occur:
• Immediately place the regulator valve at the
position OFF.
• Place the clamping lever at the position 0 to loosen
the canister from the valve.
When the canister allows itself to be released,
remove it from the gas canister shaft and isolate
it from the gas cooker.
• Provide for sufficient air circulation. Keep the
appliance away from all sources of ignition.
• Should the leak come from the gas cooker and
it cannot be stopped, move the gas cooker to
a well ventilated location that is distant from all
possible sources of ignition.
• NEVER search for a leak with an open flame, use
a soapy solution!
• Discontinue use of the gas cooker if the gas leak
has come from the gas cooker. In this case, contact
the Service Centre.
Automatic Safety Cut-Off
In the case of over-pressure in the gas canister, for
example by overheating, the valve on the gas cooker
actuates the clamping lever and separates the canister
from the valve.
In this case, wait until the canister has cooled sufficiently,
and the pressure has fallen, before continuing to use
the gas cooker.
Resetting the Safety Cut-Off
• Place the clamping lever in the position 0 and
remove the canister.
• Place the regulator valve in the ignite position to
burn off the remaining gas.
• Place the regulator valve back into the position OFF.
• Place the clamping lever into position 1 and then
back into position 0.
Determine the likeliest possible cause for over-pressure
in the canister.
Possible causes could be:
- The gas cooker was being used in direct sunlight.
- The cooking vessel is too large and caused
a build-up of heat.
- insufficient ventilation.
• If possible, continue use with a new and sufficiently
cool canister. For this, refer to the instructions in
the chapter “Commissioning”.
IB_KH4202_RP42311_LB3C 08.01.2009 9:50 Uhr Seite 3