Kohler k-10950 Plumbing Product User Manual


 
Service the Battery (cont.)
Reinstall the battery clip inside the faucet body.
NOTE: Connector Position 1 is the preferred installation location
for the connectors. Connector Position 2 may also be used as an
alternate installation location. Refer to the above illustration.
Position the connector tight to the battery clip in connector
position 1 (DC models have one connector).
Slide the faucet spout over the valve assembly. It is important
that the front of the spout line up with the pin at the bottom
front of the valve assembly.
IMPORTANT! Verify that all the wires are inside the faucet body
and are not pinched.
Convert to Tempered Water
To provide tempered water only, use a wrench to remove the
hose for the hot water after first turning off the water supply to
the faucet.
Replace the hose with the plug supplied and securely wrench
tighten.
If applicable, install the vandal-resistant plug button. Refer to the
Disassemble the Faucet section to remove the handle.
Turn on the water supply to the faucet and check for leaks.
1025498-5-H 8 Kohler Co.