Filter
Top Products
5
114552Ć2ĆCE
Kohler Co., Kohler, WI
Install elbows and adapters (if
needed) to the 1/2" copper tubing
or 1/2" pipe of the proper length.
Apply pip;e thread sealant and
connect the piping to the bath
and shower outlets of the valve.
Shower Ell 1/2"
Copper
or Pipe
1/2" Adapter
or Solder Direct
Hot Side
Bath Outlet
1/2" Copper
or Pipe
Bath Ell
1/2" Adapter or
Solder Direct
Shower Outlet
CAUTION: Risk of
product damage. The
valve assembly contains
plastic components. Remove
the stop nut and stem
assembly, valve cap and
pressure balancing unit
before applying soldering
heat to the valve body.
Connect the water supplies to the
valve body using elbows, 1/2"
copper tubing or pipe and adapters
(if needed). Use thread sealant on
all threaded connections.
IMPORTANT! Secure the piping to
the framing.
Temporarily install 1/2" nipples to
the bath and shower elbows so they
will extend at least 2" (50cm)
beyond the finished wall.
If the inner valve components had
been removed for soldering,
reinstall them now.
Pressure
Balancing
Unit
Valve Cap
Valve Body
Collar
Stop Nut
Stem
Assembly
Temporary
Nipple
1/2" Adapter
or Solder Direct
Cold
Supply
1/2"
Copper
or Pipe
Hot
Supply
1/2"
Elbow
Temporary
Nipple
Screws