Filter
Top Products
114552Ć2ĆCE
Kohler Co., Kohler, WI
4
PREPARE SITE
1.
ROUGHĆIN PLUMBING
Shut off the main water supply.
If the bathing fixture has been
installed, cover the fixture to
prevent damage to the surfaces.
Install or relocate the supply piping
as necessary.
NOTE: To improve clarity, the
plaster guard dome is not shown in
some of the illustrations.
SUPPORT FRAMING
Determine the location of the
showerhead, valve and spout.
Install the support framing.
PREPARE VALVE
2.
Carefully remove the stop nut
and stem assembly, valve cap,
collar and pressure balancing unit
before applying soldering heat to
the valve body.
Pressure
Balancing
Unit
Valve
Cap
With Stops
Without Stops
Valve Body
Collar
Stop
Nut
Stem
Assembly
Screws
INSTALL VALVE
3.
NOTE: A valve with the stops
installed is shown throughout the
instructions.
Install the valve on the support
framing so the UP" mark on the
valve is facing upward.
10" (25.4cm)
4" (10.2 cm)
48" (121.9cm)
TO FLOOR
72" (182.9cm) -
78" (189.1cm) TO
FLOOR (TYPICAL)
72" (182.9cm) -
78" (189.1cm)
(TYPICAL)
Bath/Shower
lation
Shower
Installation