Filter
Top Products
8
KMACS 5 MANUAL
© 2003 KMDSI Document # 041112001
2.2 FIRST USE OF THE KMACS 5
Place the Dive Control System on a firm surface.
The KMDSI logo should be right side up. Release
the latches and lift up the lid to expose the panels.
When using the KMACS 5 aboard a vessel subject to
waves or swell be sure to tie the KMACS 5 securely
in position so that it doesn’t fall. Thread a piece of
line through the handles and fasten the ends to fit-
tings on the boat. Tie back the lid of the KMACS 5
as well to prevent damage or injury.
2.3 CONNECTING THE AIR SUPPLY
Loosen the knurled knobs which connect the yokes
to their storage posts in the KMACS 5 and remove
the yokes (S) from the blocks. Attach each yoke
to a high pressure cylinder as you would connect
a scuba regulator to a tank. The knobs on the yoke
should be screwed down finger tight. Do not apply
Section 2.0
2.1 UNPACKING THE KMACS 5
When you first receive your KMACS 5, carefully
unpack it and examine it for any damage that may
have occurred during shipment. Be sure to complete
the enclosed warranty card and return it to KMDSI
immediately. No warranty claims will be honored
without a satisfactorily completed warranty card on
file at KMDSI.
Visually check the KMACS 5 to ensure that it has
not been damaged in transport.
Fig. 6 Connecting a scuba air supply to the KMACS 5.
Fig. 5 Note the line which passes through the handle of the
KMACS 5 and is secured to the rail to prevent the KMACS 5
from moving about.
OPERATING INSTRUCTIONS