Filter
Top Products
CAUTION! IF THE BATTERY REMINDER FINGER IS NOT HELD DOWN
IN THE BATTERY COMPARTMENT BY THE BATTERY, THE BATTERY
DOOR WILL NOT CLOSE, THE AC QUICK CONNECTOR WILL NOT
ATTACH TO THE ALARM, AND THE ALARM WILL NOT ATTACH TO
THE MOUNTING BRACKET.
After installing the battery, connect your alarm to the AC Quick Connector and
mount the unit. Test your alarm by using the test/reset button and check that
the green LED is on.
A missing or improperly installed battery will prevent the battery door from clos-
ing and result in improper alarm operation. This smoke alarm uses a 9V alkaline
battery (lithium batteries may also be used). A fresh battery should last for one
year under normal operating conditions. This alarm has a low/missing battery
monitor circuit that will cause the alarm to “chirp” approximately every 60 sec-
onds for a minimum of seven (7) days when the battery gets low. Replace the
battery when this condition occurs.
MOUNTING INSTRUCTIONS
CAUTION: THIS UNIT IS SEALED. THE COVER IS
NOT REMOVABLE!
CAUTION: WHEN WALL MOUNTING: UNIT
MUST BE MOUNTED SO THAT THE SOUNDER
OPENINGS ARE AT THE BOTTOM! (SEE FIGURE
7). INCORRECT ORIENTATION OF WALL
MOUNTED SMOKE ALARMS WILL DECREASE
OPERATIONAL EFFECTIVENESS.
1. Complete the steps in section 3, WIRELESS INTERCONNECT SETUP.
FIGURE 6 BATTERY REPLACEMENT
Battery
Finger
FIGURE 7