Filter
Top Products
14
15
D.Tamper Resist Feature:
To make your smoke alarm somewhat tamper resistant,
a tamper resist feature has been provided. Activate the
tamper resist feature by breaking off the four posts in
the square holes in the trim ring (see Figure A). When
the posts are broken off,the tamper resist tab on the
base is allowed to engage the mounting bracket. Rotate
the alarm onto the mounting bracket until you hear the
tamper resist tab snap into place,locking the alarm on
the mounting bracket. Using the tamper resist feature
will deter children and others from removing the alarm
from bracket. NOTE: To remove the alarm when the
tamper resist tab is engaged,press down on the tamper
resist tab,and rotate the alarm off of the bracket (see
Figure B).
Operating/Installation Instructions
FIGURE A
FIGURE B
A
A
Posts
Drill a hole through the pencil marks and use the enclosed
screws and anchors to secure (use 3/16”drill bit for anchor
holes).Align the Smoke/CO Alarm with the mounting plate
and rotate clockwise (right) until the unit is aligned.Screw
and anchor accessories are supplied.
Operating/Installation Instructions