Filter
Top Products
For a wall-mounted unit, you will need to pull out the removable adapter
and power cord.
To install:
1. Follow steps 1 through 4 in the previous
section under “To Rotate the Adapter.”
2. With the adapter removed, pull the power
cord out of the cord recess, remove the twist tie,
and extend the power cord.
3. With the power cord extended, press the last
few inches of the power cord back into the cord
recess. Gently pull the cord at the bottom of the
cord recess until the cord becomes taught and
lays flat in cord recess.
4. Carefully replace the back door. Insure the
“latches” on all four corners of the door are
lined up, then press the door into place.
5. Push with your thumbs in the direction oppo-
site of the arrows on the thumb grips and slide
the back door toward the top until it stops.
6. Mark the location for the two mounting holes on the wall spaced
vertically 2 5/8" apart.
7. If you are mounting the alarm in plaster board
or drywall, drill a 3/16" hole into the wall and
insert the plastic anchors provided. Install the two
screws provided into the wall or wall anchors until
the screw head is approximately 1/8" from the
wall.
8. Hook the unit over the screw head and into
the keyhole in back of the unit.
9. Plug the adapter into an unswitched wall socket.
Table Top Alarm
You can use your Carrier CO alarm as a table top unit. Follow steps 1 thru 4
above under “Wall Mounted Alarm”. Instead of mounting the unit to a wall, pull
the slide support all of the way out until it stops. You may stand the unit on a
table, bedside stand, or chest of drawers. (refer to the diagram on page 10).
Installation
Back of the alarm when used
as a wall mount unit
Cord
Recess
WALL
1/8"
12