Filter
Top Products
5
Step 5
You will either see a flashing red dot or you will see three eights in the
digital display indicating the alarm is warming up. After approximately 20 sec-
onds, the first reading will appear on the digital display. The number on the dig-
ital display should be zero (0). If not, see page 15 for complete information on
normal operating characteristics.
Step 6
Make sure the red dot in the digital display is blinking. Then test the unit’s
operation by pressing and releasing the Test/ Reset button. Within 15 seconds
you will hear 4 quick “chirps” -followed by 5 seconds of silence- followed by
4 quick “chirps”. For complete testing information, refer to page 16.
Step 7
While testing the alarm, have someone else check that the alarm can be heard
easily from the sleeping areas. The alarm should be located where it can wake
you if it alarms at night.
C
C
a
a
u
u
t
t
i
i
o
o
n
n
:
:
Continuous exposure to the loud 85 deci-
bel alarm at close range over an extended period of time may cause hearing
loss.
Your Kidde CO alarm is now monitoring for the presence of carbon monox-
ide.
Quick Set Up Guide