Filter
Top Products
For a wall-mounted unit, you will need to pull out the removable adapter
and power cord.
To install:
1. Follow steps 1 through 4 in the previous sec-
tion under “To Rotate the Adapter.”
2. With the adapter removed, pull the power cord
out of the cord recess, remove the twist tie, and
extend the power cord.
3. With the power cord extended, press the last
few inches of the power cord back into the cord
recess. Gently pull the cord at the bottom of the
cord recess until the cord becomes taught and lays
flat in cord recess.
4. Carefully replace the back door. Insure the
“latches” on all four corners of the door are lined
up, then press the door into place.
5. Push with your thumbs in the direction oppo-
site of the arrows on the thumb grips and slide the back door toward the top
until it stops.
6. Mark the location for the two mounting holes on the wall spaced
vertically 2 5/8" apart.
7. If you are mounting the alarm in plaster board or
drywall, drill a 3/16" hole into the wall and insert the
plastic anchors provided. Install the two screws provid-
ed into the wall or wall anchors until the screw head
is approximately 1/8" from the wall.
8. Hook the unit over the screw head and into the
keyhole in back of the unit.
9. Plug the adapter into an unswitched wall socket.
Table Top Alarm
You can use your Kidde CO alarm as a table top unit. Follow steps 1 thru 4 above
under “Wall Mounted Alarm”. Instead of mounting the unit to a wall, pull out
the slide support and stand the unit on a table, bedside stand, or chest of draw-
ers. (refer to the diagram on page 6).
14
Installation Instructions
Back of the alarm when
used as a wall mount unit
Cord
Recess
WALL
1/8"