Kenmore 625.3882 Water System User Manual


 
[i:ii:ii:ii:_i:i:ii:_ISECTION 2 I_i:ii:ii:ii:_i:i:ii:_] HOW YOUR WATER SOFTENER WORKS
I1_ RECHARGE TIME REMAINING and VALVE
POSITION INDICATORS
One of the valve position indica- valve recharge
position time
tors (Serv, Fill, Brine, Bkwsh, indicators remaining
Rinse) is displayed while the
softener is recharging (See *Note
on page 2-1 if the CLEAN fea-
ture is ON). RECHARGE flashes
in the display and, beginning
with Brine, the minutes of recharge remaining be-
fore return to service appears in place of the present
time. When the valve is moving from one cycle to
another, both position indicators are flashing.
I1_ PROGRAM MEMORY
If electrical power to the softener goes off, the time
display is blank but the face plate timer keeps the
correct time for about 12 hours. When electrical
power comes on again, you have to reset the present
time only if the display is flashing. The HARDNESS
and RECHARGE TIME never require resetting un-
less a change is desired.Even if the timer is incorrect
after a long power outage, the softener works as it
should to keep your water soft. However, regenera-
tions may occur at the wrong time of day until you
reset the timer to the correct time of day (page 1- 3).
I1_ ERROR CODE
An error code could appear in
the face plate display if a prob-
lem occurs in the softener elec-
tronics. Turn to page 5-2 under
"Troubleshooting" to resolve
the problem.
L_-_ _
LI I I
2-3