Filter
Top Products
INSTALLATION STEPS
STEP 4 - MAKE TUBING CONNECTIONS
1. Allowing some slack, measure and cut a length of
3/8" tubing to connect between the supply fitting
and the filter system inlet, FIG. 1. Cut the ends of the
tubing square.
2. Insert tubing all the way into the supply fitting and
inlet fitting. Pull on the tubing to be sure that it's
held firmly in the fitting.
3. Repeat steps I and 2 to connect tubing between the
filter system outlet and the adaptor on the bottom of
the faucet stud, FIG. 1.
TUBING CONNECTION
(all push- in fitting locations)
This system includes push- in fittings for quick tub-
ing connection at most locations. If working with the
fittings do the following.
Connection, FIG. 5 - A:
1. Use a sharp cutter or knife to cut the end of tubing
square.
2. Inspect the end (about 1") of the tubing to be sure
there are no nicks, scratches or other rough spots. If
needed cut the tubing again.
3. Push tubing through the collet and all the way into
fitting. Full engagement is 11/16" for 1/4" tubing,
and 3/4" for 3/8" tubing.
If tubing other than supplied with the system is
used, be sure it is of high quality, exact size and
roundness with a smooth surface.
To Disconnect Tubing, FIG. 5 - B: Push the collet in-
ward and hold with a finger while pulling the tubing
out.
FIG. 5 - A
Tubing correctly cut and connected
cut tubing s_uare
t :
I I
I
end of tubing round and
smooth, with no cuts,
nicks or flat spots
engagement -4_
_E- 3/4" (3/8" tubing) l
FIG. 5 - B
cotlet (depress to
remove tubing)
r 1
I CAUTION I
I DO NOT USE VINEGAR, OR OTHER ACID I
I BASED CLEANERS ON THIS SYSTEM. THEY I
I WILL DEGRADE SOME SYSTEM PARTS. AL- I
I WAYS USE SOAP AND WATER. I
I- .................... J
STEP 5 - FILTER CARTRIDGE INSTALLATION
Turn to page 9 and follow all steps under "Filter Cartridge Replacement".
A taste and odor cartridge contains activated carbon, a black powder. After the new cartridge is installed, open
the filtered water faucet and allow fine, harmless carbon particles to purge from the cartridge. Close the faucet
when you no longer see the "fines" in the filtered water, or approximately 2- 3 minutes.