Filter
Top Products
INSTALLATION STEPS
STEP 2 - MAKE HOLE FOR FILTERED
WATER FAUCET
Select one of the following places to install the faucet.
Be sure there's room underneath so you can make
the needed connections.
-- In an existing sink spray attachment hole.
-- Drill a hole in the sink top.
- - Drill a hole in the countertop next to the sink.
1. If drilling is needed make a 1" to 1-1/4" diameter
hole for the faucet.
CAUTION: To avoid damaging the sink, consult a
qualified plumber or installer for drilling procedures
in porcelain or stainless steel. Special drill bits are
made for this.
2. Place plumbers putty around the drilled hole to
prevent water leaks around the faucet.
FIG. 3 .... .... 1" to 1- 1/4"
diameter hole
through sink or
, countertop
p,umber
putty
STEP 3 - ASSEMBLE AND
INSTALL FAUCET
1. Faucet, FIG. 4:
1. Remove the large nut from the faucet threads.
2. Slide the faucet stud and telephone style wire
through the sink or countertop hole.
3. On the underside of the sink or countertop, screw
the nut on the faucet threads with the wire running
through the slot in the washer. Tighten the nut so
the faucet cannot move, but do not overtighten.
4. Connect tubing to push to connect fitting on bot-
tom of faucet stud per instructions on page 7.
5. Connect the telephone style wire to the recepticle
on PWA board in the manifold and route the wiring
through slots in top cover and manifold assembly.
FIG. 4
ASSEMBLED IN
MOUNTING HOLE
....
plumbers
hole in sink or
countertop
faucet & spout
gasket
/
slotted
washer
_'_----- nut
TUBING FROM DRINKING <_:71/
\
WATER SYSTEM