Filter
Top Products
PARTS OF THE SYSTEM MATERIALS AND TOOLS NEEDED
filter system assembly including mounting brack-
et and screws
water supply fitting
filtered water faucet for sink or countertop mount-
ing
3/8" tubing to make all needed connections
• plumbers putty
• Phillips screwdrivers
• pliers and adjustable jaw wrench
• tubing cutter
• pipe joint compound or Teflon tape
• electric drill and 1" drill bit if mounting hole is
needed for the faucet, see page 6
CAUTION: To avoid damaging the sink, consult a
qualified plumber or installer for drilling procedures
in porcelain or stainless steel.
FIG. 1
TYPICAL UNDERSINK INSTALLATION
filtered water
faucet
HOT/_ COLD
shutoff valve
Note: To change the fil-
ter cartridge, you must
turn offthe water and re-
lease pressure by open-
ing the faucet. A nearby
shutoff valve is conve-
nient. Most sinks al-
ready have shutoff
valves on the supply
pipes.
\
\
supply fitting
\
\
WATER
- - _ OUT
Monitor
Cable
WATER
" _ IN
tubing
/
J
Filter I Filter II
Note: Be sure to allow a minimum space of 1- 1/2" under
the system for removing the sumps, to change the
cartridges.
15-1/2"
rain.
up from
floor