Filter
Top Products
WATER SOFTENER START-UP
SECTION 1
6
1C. PROGRAM THE TIMER
FIG. 1
DOWN
button
UP
button
display
SELECT
button
ON/OFF–HOLD
button
(Recharge Tonight–Now)
SELECT
ON/OFF-
HOLD
RECHARGE TONIGHT
RECHARGE NOW
Demand Water Softener
Sears Water Line
for Customer Assistance
1–800–426–9345
Kenmore
When the transformer is plugged in, the model code
SR17 shows in the face plate display for a few
seconds, followed by a test number (example: S3.0).
After the test number, 12:00 AM begins to flash.
PRESENT TIME and RECHARGE TONIGHT show at
the bottom of the display.
NOTE:
If SR --is flashing in the display, press the UP
button (FIG. 1) until SR17 shows. Then, press the
SELECT button to display the flashing 12:00 AM. If
other than SR17 shows, when the transformer is
plugged in, please see page 17 to reset.
SOUND BEEPER": A beeper" sounds while
pressing buttons for timer setĆup. One beep signals a
change in the face plate display. Repeated beeps
means the timer will not accept a change from the
button you have pressed, telling you to use another
button. For example, in setting the hardness (step 2),
the beeper sounds repeatedly when the display
reaches 1 using the DOWN button, or the highest
hardness setting using the UP button.
1. SET PRESENT TIME OF DAY:
NOTE:
If the words PRESENT TIME do not show in the disĆ
play, press the SELECT button (FIG. 1) until they do.
■ Press the UP/DOWN buttons to set the
present time. Press UP to move the display ahead;
press DOWN to move the time backward.
If the present time is between noon
and midnight, be sure PM shows.
If the present time is between
midnight and noon, be sure AM
shows.
NOTE:
Each press of the UP or DOWN buttons changes the
time by 1 minute. Pressing and holding the buttons
changes the time 32 minutes each second.