Filter
Top Products
PROCEDURE C
H To achieve rearward slope for unit draining,
remove the backing from the 11t3/16" shim
strips and attach them as shown below in Fig.
23. The higher portion of shim is to be placed
in front of the rib on the base of wall sleeve.
"h'0hl[ lI3,<.,g.
FIG, 22
FIG. 23
_J Remove the metal rear grille and replace it with
the plastic rear grille to improve unit energy
efficiency. The plastic grille reduces the
amount of hot air discharge that recirculates
through the unit,
Plastic remr grille
Steel rear
• Airconditionerscoveredin thismanualposean
excessiveweighthazard.Twoor morepeopleare
neededto moveandinstalltheunit.
Topreventinjuryor strain,useproperliftingand
carryingtechniqueswhenmovingunit.
• Whenhandlingtheairconditioner,becarefultoavoid
cutsfromsharpmetalfinsonfrontandrearcoils.
• Makesureairconditionerdoesnotfallduring
removal.
• Ifunitdoesnotoperateafterinstallationcheck,tobe
surethecircuitinterrupterhasnotbeentripped.Refer
totheTroubleshootingguideforresetprocedure.
/
FIG. 24
I_ Install the new unit into the wall sleeve
_1 Assemble trim as described in Step 6,
Procedure A.
-11 -