Filter
Top Products
PROCEDURE C
_1 Redirect the louvers at the back of the wall
sleeve to 60° angle as shown in the FIG 16.
The use of pliers is recommended.
7 3132"
Rear Louvers
(Top View)
FIG. 16
I_ll Ifthe wall sleeve already has a rear grille, skip
to step 4. Ifthe wall sleeve does not have a rear
grille or Iouvered panel, install the plastic grille
from the kit. Cut the plastic grille to 26-1/2" wide
and 15-1/2" high. Place the plastic grille to the
inside of the wall sleeve at the rear flange.
Place the plastic grille
FIG. 17
I_ Fasten the 4 washer screws to secure the grille
to the wall sleeve. If you need plastic nuts to
mount plastic grille to the inside of the wall
sleeve, there are plastic nuts inthe installation
kit. The nuts are installed from the inside of the
sleeve and are pressed into the square holes of
the rear flanges.
Fasten the screws FIG 18
I_ Remove the backing from the Horizontal
Insulation strip 237/32x 13/8x 13n6and attach
that to the inside right of the sleeve as shown
below. Remove the backing from the Around
Insulation strip 5927/32 X 13/8X 13/8and attach
that to the inside front of the sleeve as shown
below<
Indoor Outdoor
_lf the depth of your existing sleeve is less than
or equal to 18", skip to step 7. Otherwise, cut
the baffles and the support blocks according to
Length "A" in the table below.
Depth"D" ofthe existing Length"A"
wailsleeve(inches) (inches)
t8 <D_<t8-% 3/4
18-%<D_t9-3/_ 1-3/4
t9-3/_ <D_<22 4
_F Baffle
IG. 20
r_ Remove the backing from the support blocks
and attach them to the inside of the wall sleeve
as shown FIG 21. Slide the baffle into slots of
the support blocks
Wall
Wall
Sleeve
J
Support
Block
FIG. 21
-10-