Filter
Top Products
Cleaning the Shuttle Race
This area must be kept free of dust, lint and
occasional tangled thread. Clean the shuttle race area
about every three months.
• Cleaning the shuttle area
(_ Bobbin case
_) Levers
_) Shuttle race cover
(_ Shuttle
@ Shuttle race
_) Center pin on the shuttle
1. Raise the needle bar to its highest point and remove the
bobbin case _1_.
2. Push shuttle race levers _ aside. Lift shuttle race cover
(_ and take shuttle _ out.
3. Clean the shuttle race @ with a lint brush.
4. Put a drop of oil on the center pin of the shuttle (_ and
shuttle race @. Do not over oil.
S
• Replacing shuttle assembly
(_ Levers
_) Shuttle race cover
(_ Shuttle
@ Shuttle race
_) Center pin on the shuttle
(_ Shuttle driver
(_ Pointed hook
(_ (Oil here)
1. Turn handwheel so that shuttle driver (_ is forming half
moon on the left side of the machine.
2. Hold shuttle(_ by center pin (_ and position shuttle so
as to form a half moon on the right side. The pointed
hook wilt be on the bottom.
3. Place shuttle race cover _) into place over shuttle
assembly.
4. Snap the levers _ back into the original position.
s
@-
®
7O