Filter
Top Products
SEWINGMACHINEDtV.20 MODEL384.15358
FEED DOG HEIGHT
MECHANICAL ADJUSTMENT
MACHINE SETTING
1. STITCH SELECTOR: " 1CiD"
2. NEEDLE BAR: AT ITS HIGHEST POSITION.
TO CHECK:
1. RAISE THE PRESSER FOOT.
2. PLACE THE FEED DOG HEIGHT GAUGE #68367 "A" ON THE NEEDLE
PLATE.
3. TURN THE HANDWHEEL TOWARD YOU BY HAND AND CHECK THE FEED DOG
HEIGHT. REFER TO CHART BELOW.
ADJUSTMENT PROCEDURE:
1,
2.
OPEN THE SHUTTLE COVER. LOOSEN THE SCREW (A).
ADJUST THE FEED DOG HEIGHT BY TURNING THE FEED LIFTING PIN.
WHEN THE FEED DOG HEIGHT IS HIGHER THAN THE STANDARD RANGE, TURNS
THE FEED LIFTING PIN tN THE DIRECTION OF "B".
WHEN THE FEED DOG HEIGHT IS LOWER THAN THE STANDARD RANGE, TURN
THE FEED LIFTING PIN IN THE DIRECTION OF "C".
FACE (A)
1.25 MM
NOT MOVING
NOT MOVING
MOVING
GAUGE
FACE (B) (RED)
1.00 MM
MOVING
NOT MOVING
MOVING
FEED DOG HEIGHT
CORRECT
LOW
HIGH
A #68367 /
FEED LIFTING PIN
18