Filter
Top Products
TO EMPTYTHESOLUTION TANK
SeeFigure 1I
When cleaning is completed, both the Recovery Tank and the
Solution Tank should be emptied prior to storage. Empty the
Recovery Tank as described earlier. There are three methods
of emptying the Solution Tank.
Method 1:
1. Disconnect Short Cord from Recovery Tank.
2. Remove Recovery Tank from Solution Tank and pour
solution out of the Filler Opening.
Method 2:
1. Place Floor Nozzle in bath tub or container.
2. Depress Solution Release Trigger and spray until empty.
Method 3:
1. Remove Floor Nozzle and insert Wand into Solution
Tank through the Filler Opening.
2. Vacuum solution out.
3. All solution is now in Recovery Tank. Empty Recovery
Tank as described earlier.
Jr
/
METHOD 2
, illllllLitJi
METHOD 1
METHOD 3
UPHOLSTERYNOZZLE
See Figure 12
Cleanmore Carpet Cleaner Upholstery Nozzle is an attach-
ment for furniture upholstery cleaning. The upholstery
nozzle may also be used to dean auto upholstery or carpet-
ing. In addition, the nozzle may be used to clean carpeted
stairs and other areas difficult to clean with the normal floor
nozzle.
FLOORTOOLS
See Figure i3
The Bare Floor/Carpet Brush (1) may be used on floors
without carpet for DRY cleaning with paper dust bag in-
stalled.
The Squeegee Attacbanent (2) is useful for WET pickup.
CA UT/ON: D O NOT run the Pump Motor when using these
attachments. To prevent Pump Motor from operating, make
sure Pump Motor Switch is in "OFF" position, or unplug the
Short Cord from the Solution Tank to the Recovery Tank.
® ®
%%