Filter
Top Products
ASSEMBLYOF RECOVERYTANK
AND SOLUTIONTANK
SeeFigure2
1. Place Recovery Tank into Solution Tank (align the word
"VACUUM" on Recovery Tank with "VACUUM" on
Solution Tank) and secure with Metal Latch.
2. Insert the plug on the Short Cord from the Solution Tank
into the Recovery Tank Power Head.
ASSEMBLYOF HOSE,WANDS,
NOZZLEAND SOLUTION TUBING
See Figure 1
1. Assemble the two Straight Wands.
2. Assemble the upper Straight Wand to the Angled Wand
of the Hose.
3. Assemble the Floor Nozzle to the lower Straight Wand.
NOTE: Be sure locking button engages properly when
assembling straight wands, angled wand, and floor
nozzle.
4. Push the Solution Tube Quick-DisconnectNutonto Trig-
get Valve. Twist clockwise to lock. See DETAIL "A" -
Figure 3,
5. Push Solution Tube into Retaining Clips on Wands. Tub-
ing may be wrapped around Wands to take up excess
slack.
6. Attach the Vacuum Hose to Recovery Tank inlet
(Vacuum Inlet).
7, Push solution tube quick disconnect nut onto the quick
disconnect valve. Turn clockwise so valve posts lock into
notches in nut. See DETAIL "B" - Figure 3.
NOTE: To remove metal retaining clips from hose and solution
tube, squeeze tube with fingers beforeremoving, Clips will dislodge
easily. Also squeeze tube befvre reattaching clips to prevent hose
punctures.
POWER
PLUG
SHORT
CORD IN
HERE
SHORT
CORD
LATCH
TRIGGER
VALVE
SOLUTIONTUBE
NUT
POWER
HEAD
RECOVERY
TANK
SOLUTION
TANK
RETAINING
CLIP
INLET
SOLUTIONTUBE QUICK
DISCONNECT NUT
QUICK DISCONNECT
VALVE
DETAIL"B"