Filter
Top Products
PROBLEM
!. Neither vacuum motor nor pump motor
runs.
2. Vacuum motor runs, but lhere is no
sp_ay at lhe nozzle.
,
4,
Spray from The floor nozzle does not
come out evenly,
Motor runs but cleaner does not pick up
solution from carpet (no exhaust from
top of cPeaner).
5 Sp_ay connections leak.
POSSIBLESOLUTIONS*
!. Be sure power switch is in "ON" position,
2. Be sure power cord is plugged in secure!y,
3. Check wall electrical outlet (by piuug,_,_, in Q i-:nc_wn
working electrical appliance).
1. Be sure Short Cord from Power Heo,_,-_!o Sok_tion 1,;_nkis
securely plugged into receptacle on Jhe Powe,, '_-_,_
2. Check that Solution Tank isfull.
3, Be sure Pump Switch is in the "HI" or "LO _ _,,._,--,,._,,:,,r
4. Nozzle Ports may be clogged. See ilIust[otic'n b_kTv,.' tc.
unclog
t. Unclog the Nozzle Port, See illustration be!ow.
!. Recovery Tank tsfull of dirty water and mus! be emptied.
2, Check for clogged hose o,,nozzle. C._og_co,._d ._e_._t from
picking up materialsuch as carpet strings,shoe' "-=_ ',*, -
1, Disassemble. nut at leaking connection. Be scue w,._s[<, i,;-
properly seated, Rea&semble and +_*'_,+^'_,-_=c-...._,,
m
* Ifthe "Possible Solutions" to "Problems" listed in the chart do not correct the problem, take your ciea[_e_ to QSears
Service Center for professional service. Repairs not listed in this chart require professional and specific k_owledge
of this model cleaner and could resull in safety hazards and personal injuryifr_otmade by a qual[_ed Sear_ Service
Technician.
TO UNCLOG NOZZLEPORT
See Figure 18
1. _msertthe point of a needle or pm into Spray Port to
unclog.
NOTE: Do not let the point of needle or pin touch any
part of the Spray Pad surface or Spray Pad will not
spray scflution properly.
SPRAY POR!
\\
x
CAUTION: Do not _etneedi÷
or pin touch this. surface,
\
\
\