Kenmore 15358 Sewing Machine User Manual


 
SECTION ill. STRAIGHT STITCH SEWING
Straight Stitch
'_1_'Stitch pattern selector:
'(2_'Presser foot:
,_3_Needle thread tension:
_:4_Stitch length:
1-2
Zigzag foot
2to6
1.5 - 4
Starting to sew
Raise the presser foot and position the fabric next to a
seam guide line on the needle plate (518" [1.6 cm] is most
common). Lower the needle to the point where you want
to start. Lower the presser foot and pull the threads
toward the back. Depress the foot control. Gently guide
the fabric along a seam guide line letting the fabric feed
naturally.
. Finishing sewing
To fasten the ends of a seam, press the reverse stitch
control and sew several reverse stitches. Raise the
presser foot. Remove the fabric, draw the threads to the
back and cut them with the thread cutter. The threads are
now the proper length to begin sewing the next seam.
CAUTION: Do not place fingers near the presser foot
when guiding fabric, or the needle clamp screw may
strike and injure your fingers. ...........
,:Ji
I I
_\3_ _
\\\\\\\
J
Use the Seam Guides
_, Cornering guide
_2_,Guide lines in inche_
_3_Guide lines in mill
The seam guides plate are
measure seam plate
indicate the position
and the edge of i" (0.3 cm)
apart, and are enc _nd6/8". The
lines in millimeters are engraved at 10
mm, 15 mm and 20 mm.
Turn a Square Corner
,:,_1_Cornering guide
When sewing with fabric edge at 5/8" seam guide, to turn a
square corner so that sewing continues at the same
distance from edge:
1. Stop stitching when the front edge of the fabric reaches
the cornering guide lines.
2. Lower the needle by turning the handwheel
counterclockwise.
3. Raise the presser foot and turn the fabric
counterclockwise 90°.
4. Lower the presser foot and begin stitching in the new
direction.
f
36