Filter
Top Products
Installation Instructions (cont'd)
Water Piping
AWARNING
HOTTER WATER CAN SCALD: Water heatersare intendedto
produce hot water. Water heated to a temperature which will
satisfyclotheswashing,dishwashing,and other sanitizingneeds
can scaldand permanently injure you upon contact. Some peo-
ple are more likelyto be permanently injured by hot water than
other_ These includethe elderly,children,the infirm, orphysical-
ly/mentally handicapped.If anyone usinghot water in your home
fits into oneof thesegroupsor if there isa localcodeor state law
roquiHng a certaintemperature water at the hot water tap, then
you must take specialprecautions.In additionto usingthe lowest
possibletemperature setting that satisfies your hot water needs,
a meanssuchas a mixing valve, shouldbe usedat the hot water
taps used by these people or at the water heater. Mixingvalves
are availableat plumbing supplyor hardware stores.Followman-
ufacturers instructions for installation of the valves. Before
changing the factory setting on the thermostat, read the
"Temperature Regulation"sectioninthismanual.
This water heater shallnot be connected to any heating systems or
component(s) used with a non-potable water heating appliance.
If a water heater is installed in a closed water supply system;
such as one having a back-flow preventer, check valve, water
meter with a check valve, etc.., in the cold water supply; means
shall be provided to control thermal expansion. Contact the
local utility or local Sears Service Center on how to control this
situation.
Look at the top cover of the water heater. The cold water
inlet is marked cold. Put two or three turns of teflon tape
around the threaded end of the threaded-to-sweat coupling
and around both ends of the _" threaded nipple. Using flexi-
ble connectors, connect the cold water pipe to the coldwater
inlet of the water heater.
NOTE: This water heater is super insulated to minimize
heat loss from the tank. Further reduction in heat loss
can be accomplished by insulating the hot water lines
from the water heater.
INSTALLATION COMPLETED USING
SEARS INSTALLATION KIT
HOT OUTLET
TO HOUSE
_IIE--
/
THREADED TO
SWEAT COUPLING
FLEXIBLE WATER
CONNECTORS
COLD INLET
WATER LINE
THREADED TO
SWEAT COUPLING
NOTE: Toprotect against untimely corrosion of hot and
cold water fittings, it is strongly recommended that di-elec-
tric unions or couplings be installed on this water heater
when connected to copper pipe.
The illustration shows the attachment of the water piping to the
water Con-
water heater. The water heater is equipped with +"
nections.
NOTE.' If using copper tubing, solder tubing to an adapter
before attaching the adapter to the cold water inlet connec-
tion. Do not solder the cold water supply line directly to the
cold water inlet. It will harm the dip tube and damage the
tank.
• Look at the top cover of the water heater. The water outlet is
marked hot. Put two or three turns of teflon tape around the
threaded end of the threaded-to-sweat coupling and around
both ends of the _+' threaded nipple. Using flexible connec-
tors, connect the hot water pipe to the hot water outlet on
the water heater.
314"THREADED
HEAT TRAP WITH
SECONDARY
ANODE
-- 314" THREADED
HEAT TRAP
--TEMPERATURE-
PRESSURE
RELIEFVALVE
-- DISCHARGE
PIPE (Do not
caporplug)
--6" AIR GAP
FLOOR DRAIN
11