Filter
Top Products
2_
3.
4,
5.
6,
7,
Make sure the electrica! supply to your water heater is
"ON"_
Check for loose or blown fuses in your water heater circuit.
Circuit breakers weaken with age and may not handle
their rated load and should be replaced.
Make certain the disconnect switch, if used, is in the 'ON"
position.
Check to see the electric service to your house has not
been interrupted. If this is the case, contact the electric
company.
Is the thermostat set to the desired temperature? See
"Temperature Regulation" section.
If you had experienced very hot water and now no hot
water, the problem may be due to the high temperature
shut off system. See "High Temperature Shut Off System"
in the 'Troubleshooting" section.
8. During very cold weather, the incoming water will also be
colder and it will require a longer time to become heated.
g,
The hot water usage may exceed the capacity of the water
heater. If so, wait for water heater to recover after abnormal
demand. Also examine pipes and faucets for possible
water leaks.
10. If you can not determine the problem, then call the Sears
Service Department.
WATER JSTOO HOT
Adjust the thermostat to a lower setting. See the 'Temperature
Regulation" section.
Leakage Checkpoints
Read and understand instruction
manual and safety messages
before installing, operating or
servicing this water heater
Fai0ure to follow instructions and
safety messages could result in
death or sedous injury.
Hnstruction manual must remain
with water heater.
Read this manual first. Then before checking the water heater
make sure the electric supply has been turned 'OFF", and never
turn the electric supply "on" before the tank is completely full of
water.
Use this guide to check a "Leaking" water heater. Many
suspected ' Leakers" are not leaking tanks. Often the source of
the water can be found and corrected.
Small amounts of water from the temperature-pressure
relief valve may be due to thermal expansion or high water
pressure in your area.
*The temperature-pressure relief valve may be leaking at
the tank fitting.
The element may be leaking at the tank fitting.
Before removing any access
panels or servicing the water
heater, make sure the dectrical
supply to the water heater is
turned "OFF"
_' Failure to do this could result in
death, serious bodily injury, or
property damage
If you are not thoroughly familiar with electric codes, the water
heater, and safety practices, contact your local Sears Service
Center to check the water heater.
mmproper installation and use may result
in property damage.
Fill tank with water before operation
Never use this water heater unless it is completely full of water.
To prevent damage to the tank and heating element, the tank
must be filled with water. The water must flow from the hot
water faucet before turning "ON" power.
*Condensation may be seen on pipes in humid weather or
pipe connections may be leaking.
Turn electrical power "OFF", remove access panel and
insulation cap with handle. If leaking around element, follow
proper draining instructions and remove element. Reposition
or replace gasket on element. Place element into opening and
tighten securely. Then follow 'Filling the Water Heater"
instructions in the 'Installation Instructions" section.
Water from drain valve may be due to the valve being opened
slightly
*The drain valve may be leaking at the tank fitting.
Water in the heater bottom the floor be from
water
or on
may
condensation, loose connections or the temperature-
pressure relief valve. DO NOT replace the water heater until
a full inspection of al! possible water sources is made and
necessary corrective steps taken.
Leakage from other appliances, water lines, or ground seepage
should also be checked.
25