Filter
Top Products
REMOVING LINT
1.
2.
3.
4.
5.
6.
7.
8.
Turn hand wheel toward you until needle is at its highest
position. Remove bobbin and bobbin case.
Push buttons (A) sideways.
Remove shuttle race cover (B). Then pull out shuttle
(C) by grasping axle.
Remove accumulated lint and thread from all parts of
shuttle race.
Replace shuttle in race body, with axle facing out, forming
a perfect circle with driver (D).
Replace shuttle race cover (B), then insert bobbin and
bobbin case.
Do not attempt to force any of the above operation.
Occasionally remove the needle plate and clean feed dog
with a soft brush.
REPLACEMENT OF THE BELT
Push motor against machine and remove belt from motor
pulley. Let motor down gently. Pull belt out over hand wheel.
Install new belt reversing the above procedure.
\
\
\
©
\
\
®
25
• • Z.