Filter
Top Products
Set up the machine
Top thread tension control
; O, 2 4.6.8
See page 17.
Stitch width control
Stitch selector
i Buttonhole foot
Feed cover plate
k. on needle plate
Stitch length control
Not necessary to
adjust
J
nlnn
I, ao
b.
C.
d.
2, a.
b.
C.
d.
Remove the extension table.
Raise the needle to its highest position.
Remove the presser foot.
Position the feed cover plate in place.
Open the bobbin access cover.
Make sure the lock lever of the
buttonhole adapter is at the right
released position.
Pulling the density control knob toward
you, insert the two hooks of the
buttonhole adapter between the two
pins located under the needle plate.
Push the lock lever away from you until
the adapter snaps into place.
Hook
Lock
lever
Density control
knob
51