Filter
Top Products
CARING FOR THE MACHINE .........
.............................. _...............______,_.__._,__
CLEANING AND OILING
Fig, 1 Cleaning the feed dogs with a
brush.
Fig. 1
ShU_ Sly
Shuttle Race Cover
i:il- !
pointed._.,.
hook "
Shuttle
Shuttle Race
Fig. 2
To insure the best possible operation
of your-machine, it is necessary to
keep the essential parts clean at all
times. Using a small brush, remove
the lint that accumulates in the shuttle
area and around the feed dogs.
Fig. 2 Parts of the Shuttle Assembly
-To Clean the Shuttle Area:
=
This area must be kept free of dust,
lint and occasional tangled thread.
Raise the needle bar to its highest
point and remove the bobbin case.
2. Push levers of shuttle race aside
and lift shuttle race cover and shut-
tle out.
3. Clean the shuttle race with small
brush.
4. Put a drop of oil on the center pin
of the shuttle and shuttle race.
(see arrows)
To
1.
,
.
Replace Shuttle Assembly:
Position shuttle race as illustrated so
that shuttle driver is forming half
moon on the left side of the
machine.
Hold shuttle by center pin and
position shuttle so as to form a half
moon on the right side. Pointed
hook will be on the bottom.
Place shuttle race cover into place
over shuttle assembly.
44