Filter
Top Products
TO REMOVE DUST BAG
! WARNING
Always unplug power cord from
electrical outlet before performing
any maintenance on the vacuum
cleaner.
1. Pull out on the
bag cover release
located near the
top of the bag
cover.
Bag
Bag //_'_
2. Pull the bag
cover forward
and lift up.
Remove and lay
aside.
3. Grasp the dust bag
collar and pull gently,
carefully removing
the dust bag.
4.Throw away the
used dust bag.
Do not reuse dust bag.
- Beg Holder
Safety
Filter
,,Dust
Bag
Check the bag
holder and the
motor safety fil-
ter. If either is
blocked, check
TROUBLE-
SHOOTING.
CAUTION
NEVER REUSE A DUST BAG.Very
fine materials, such as carpet fresh-
ener, face powder, fine dust, plaster,
soot, etc. can clog the bag and
cause it to burst before it is full.
Change bag more often when vacu-
uming these materials.
TO REPLACE DUST BAG
1. Unfold the Dust
new dust bag. Bag
Fold the safety
seal tab on the
new dust bag
/,
away from the //
opening that
/
fits on the bag
holder.
NOTE: See PARTS AND FEATURES for
bag number.
Seal Tab
B
2. Insert the dust
bag onto the bag
O
holder completely
by holding the bag
collar.
3. Place the dust bag
collar into position.
4. Tuck the bag
behind each of the Bag
four bag retention Retention
Comer
corner flaps shown Flaps
here. Be sure the
bottom and sides
of the dust bag are
completely within
bag cavity prior to
replacing the bag
cover.
Slots
5. Position the bag
cover so its posi-
tioning tabs fit into
the body position-
ing tab slots.
6. Close the bag
cover.
You will hear a
distinct snap Bag
when cover is
securely closed.
Check to see that the dust bag is fully
enclosed in the bag cover.
15