Filter
Top Products
TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacuum
cleaner, the agitator must be cleaned every+
time the belt is changed.
The agitator must also be cleaned accord-
ing to the following schedule:
Vacuum Cleaner Use
HEAVY -
(used daily)
MODERATE -
(used 2-3 timeslweek)
LIGHT +
(used I time/week)
_itator
every week
eveF_
every 2 months_
IMPORTANT
Turn off and unplug vacuum cleaner from
electrical outlet, Check and remove hair,
string and lint build-up frequently in the
PowerMate agitator and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area,,
Carefully remove any stdng or debris
located on the agitator or end caps,
AGITATOR ASSEMBLY
_ End Cap Belt Path q
Brush Unit End Cap _
then over be
path.
Drive
Agitator End Cap
NOTE: See PARTS AND FEATURES for
Belt number,
2oPlace agitator
assembly into
PowerMate.
3. NOTE: On dirt sensor models be sure
that the dirt sensor board isupright and the
wires are tucked back in place
4+Line up front of cover and base Rest
cover on front edge of base as shown,
5. Rotate cover
back., Press cover
firmly until side
latches snap into
place+ "",
6. Make sure there is no gap between the
cover and base and that the rear latches
are snapped in place,,
7, Turn PowerMate upside down and
replace two (2) cover screws,
2O