Filter
Top Products
TO REPLACE BELT
1, Instaft new
belt over
motor drive,
then over
belt path,
NOTE: See
PARTS AND
FEATURES
for Belt number.
tor
Drive
\ A;XY "- .o1,
\ --\ Path
Agitator End Cap
i
2. Place agitator
assembly back into
PowerMate
3, Line up "/_/'///'_
front of
cover and
base, Rest _
cover on _',
front edge
of base as
shown
Cover Base
l I:" x_
Side Rear
Latch Latches
4. Rotate cover
back Press
cover firmly until
side and rear
latches snap
into place.
Make sure there
is no gap between the cover and base
5. Turn PowerMate upside down and
replace two (2) cover screws
1. Remove PowerMate cover as shown in
BELT CHANGING AND AGITATOR
CLEANING section,
2. Push in and turn
bulb counterclock-
wise, then pull out
to remove,
Push In
3. Push in and turn
bulb clockwise, to
replace Bulb must
not be higher than
15 Watts (130 'Colts)
4.Reinstall PowerMate cover as shown in
BELT CHANGING AND AGITATOR
CLEANING section
NOTE: See PARTS AND FEATURES for
Bulb number,,
18