Filter
Top Products
TO REPLACE BELT
1. Install new
belt over
motor drive,
then over
brush sprock-
et.
NOTE: See
PARTS AND
FEATURES
for belt number,
End Cap
Motor
Brush Drive
Sprocket
Agitator
2. Place agitator
assembly back into
Power-Mate®.
3. Reinstall
agitator cover
by lining up
the front tabs
and slots and
rotating
downward
until the
latches snap
into place.
Agitator Cover
4. Line up
front of
cover and
base. Rest
cover on
front edge of
base as
shown.
5. NOTE: On dirt
sensor models
be sure that the
board is upright
and the wires are
tucked back as
shown.
6. Rotate cover
back. Press cover
firmly until side
and rear tabs snap
into place. Turn
Power-Mate®
upside down and
replace two (2)
cover screws.
\
Cover Base
[ Top View
\
1. Remove Power-Mate® cover as shown in
BELT CHANGING AND AGITATOR CLEAN-
ING section.
-_Push In _
And Turn
2. Push in and turn
bulb counterclock-
wise, then pull out
to remove.
Push In
And Turn
3. Push in and turn
bulb clockwise,to
replace. Bulb must
notbe higherthan
15 Watts(130 Volts).
4, Reinstall Power-Mate ® cover as shown in
BELT CHANGING AND AGITATOR CLEAN-
ING section.
NOTE: See PARTS AND FEATURES for
bulb number.
18