Filter
Top Products
SOME MODELS TO CLEAN THE LENSES
The dirt sensor light system is mounted on
the Power-Mate ® nozzle near the reset but-
ton. It consists of a series of three red lights
and one green light.
The lights give
you an indica-
tion of the
amount of dirt
particles that
are passing
Dirt Sensor thru the sensor
(Some Models) on its way to
the dust bag.
INITIAL START UP
When the Power-Mate ®is first started, the fol-
lowing light sequences occurs in a two sec-
ond time frame:
1. All three reds come on.
2. Two reds are on.
3. One red is on.
4. One green is on and will remain on until
the Power-Mate" nozzle is placed in use,
NOTE: If the nozzle is on a surface that has
dirt on it, dirt will be picked up by the vacuum
and one or more red lights might stay on.
IN OPERATION
When the Power-Mateeis being moved back
and forth on the floor, the lights willchange
from one configuration to another as more
dirt or less dirt is being vacuumed. As longas
one or more red lights are on, dirt is passing
through the wand to indicate that the surface
still needs cleaning.
When the green light stays on as the Power-
Mate e is moved back and forth over an area,
the sensor is not seeing enough dirt to war-
rant further cleaning of that area.
NOTE: Dirt sensor lights DO NOT function in
the FLOOR setting.
CLEANING LENS
Although the dirt sensor feature in your
Kenmore Power-Mate ®is designed for years
of trouble free use, the passage of dirt
through the air passage system can coat the
lens causing the green light to come on and
stay on - never switching to red. When this
happens the lens must be cleaned.
1. Remove the
wands by press-
ing the quick
release pedal and
lifting up on the
wands.
Cross Section View
Ap_prox.
3 '/, inches
or 90 mm
Elements
2. As indicatedby the illustration, the two dirt
sensor elements are located on the insideof
the swivel, approximately 31/2inches/90 mm
down, (note the arrows). Each element
should be cleaned periodically.To reach the
sensor elements, use a small brush such as
a bottle brush. Brush each sensor element
several times to remove dust and dirt.
NOTE: Looking down inside the swivel you
will see a ring. The sensor elements are
located just slightly below this ring.
3. Reinstall the wandsaftercleaning the sen-
sors.
Never use water or any cleaning
solution when cleaning the lenses,
1"he residue of the water or cleaners
will accelerate the reeoating of the
lenses and make cleaning necessary
sooner.
10