Kenmore 114.85925 Carpet Cleaner User Manual


 
WASH AND
DRY
Step on Nozzle Setting
pedal if necessary to
switch from HARD
FLOOR DRY VAC to
WET SCRUB & VAC
position.
Slide Brush On/Off
switch to the ON
position.
Pull Solution Trigger
to start the flow of
cleaning solution.
NOTE; Cleaner will
continuously dispense
solution until Solution
Trigger is released.
With solution On/Off
trigger held down,
slowly push unit
forward. Release
solution On/Off trigger
and pull unit backward
in the same area
cleaned to remove
dirty water and solution
from hard floor.
Overlap strokes by
one inch to prevent
streaking. (For heavily
soiled areas, repeat if
necessary).
IMPORTANT: If the unit stops picking
up dirty ater and/or the motor changes
to a hi, dirty water tank is full
be emptied. See page 13.
RNING
To r, uce the risk of Injury from
_1: unplug before
IMPOI
hard
4T: When changing between
nd carpet cleaning modes,
use the correct nozzle:
;leaning - tangerine nozzle
ning - green nozzle
bee)
Turn Nozzle Lock Tab
counterclockwise to
unlock nozzle from
cleaner.
Pull nozzle forward to
remove completely
from Nozzle Lock.
Store nozzle in Nozzle
Storage Holster and
clip,
NOZZLE
LOCK TAB
10