Kenmore 10101 Sewing Machine User Manual


 
7. CARE FOR YOUR MACHINE
Chan_je the light bulb
1. Unplug the machine.
2. a. Using the screw driver, push down the
lever located behind the presser bar and
the bulb will come out.
b. Push the lever to the right to lock.
3. a. Push up the bulb and turn slightly to the
left.
b. Pull down to remove it.
4. a. Insert the new bulb and turn it with
some upward pressure until it stops.
b. Push up the bulb and turn to the right to
lock into place.
5. Push the lever back to the left and then up
into the machine.
54
1:1
Clean your machine
Factory lubricated parts will provide years of
household sewing without routine oiling.
To retain the high quality level built in your
machine, clean it regularly. Watch for lint
collecting around the needlebar, bobbin case
holder locating pin and feed dogs. Whenever
changing the bobbin or needle, "observe these
areas and clean as necessary. Sears service
technicians will routinely check for possible
lubrication needs whenever your machine
requires service.
Clean the feed dogs
1. Unplug the machine and remove the
presser foot.
2. Remove the needle plate by loosening the
two screws with the large screw driver.
3. Use the brush to remove the lint that
accumulates in and around the feed dogs
and shuttle area.