Filter
Top Products
10
NOTE: There is a tip-over
switch fitted to this heater. If
the heater is tipped over, it
will automatically turn off. The
heater will need to be placed
back into the upright position,
the heater will be in standby
mode and the settings will
need to be selected again.
Setting the Oscillation
This function will work in any mode.
Pressing the ‘SWING’ button will allow
the heater to oscillate side to side.
To stop the unit oscillating, press the
‘SWING’ button once more.
Setting the Auto-Off Timer
The timer function works in all operating
modes and switches the unit off after a
preset number of hours.
• Select the desired setting.
• Press the ‘TIMER’ button to
activate the timer settings.
• Press the ‘TIMER’ button to cycle
through in 0.5 hour increments,
up to 8 hours.
• Once the TIMER is set to the desired
set time, the TIMER will count down
in 0.5 hour increments, showing
on the LCD screen the remaining
operating time. The heater will then
switch itself to standby mode with
no heat output after the selected
number of hours has passed.
Setting the Variable
Temperature
The variable temperature can be
used to maintain your desired
room temperature.
NOTE: The variable temperature
only operates when the heater
is set to AUTO mode.
1. Press the ‘MODE’ button until the
heater is set to AUTO mode.
2. To adjust the temperature settings,
press the ‘TEMPERATURE’ (+)
button to increase and (-) to
decrease the temperature. The
desired temperature can be set
between 15°C and 35°C.
3. When the air temperature
reaches 2–3°C above the chosen
set temperature, the heater will
automatically cut out and the
LCD screen turns OFF, however
the fan may continue to run for
approximately 15 seconds to
cool the heater.
4. When the air temperature drops
below the set temperature, to
maintain set temperature the
unit will begin heating again.
Using the Remote Control
The remote control buttons operate
in the same way as those on the
heater control panel. Your remote
control requires 2 x “AAA” batteries
and can be conveniently stored in
the compartment on the rear housing
of the heater (please note batteries
are not included). Ensure the remote
has uninterrupted line of sight to the
remote control signal receiver.
Using Your Kambrook Heater continued
KCE340_IB_A12.indd 10 2/11/12 11:37 AM