3
Table of Contents
Specifications ................................... 2
Installation / Service Tools ............ 2
General Information ....................... 3
Safety Information .......................... 4
Installation Requirements
Framing ............................................ 4
Mantel Clearances ........................ 6
Hearth Protection ......................... 6
Vent Requirements ....................... 7
Vertical Termination ..................... 8
Horizontal Termination................ 8
Terminal Clearances...................... 9
Vent Restrictor ............................. 10
Fireplace Assembly
Blower Installation...................... 10
Gas Connection ............................12
Gas Pressure.................................. 12
High Altitude Adjustment ........ 13
Fuel Conversion............................ 14
Wall Thermostat .......................... 16
Remote Control ............................ 16
Antique Brick Kit .......................... 17
Log Set Installation .....................18
Surround Assembly..................... 19
Double Door Installation ...........19
System Check................................ 20
Operation......................................... 22
Maintenance................................... 23
Glass Replacement ........................23
Illustrated Parts Breakdown .......24
Replacement Parts List .................25
Service Log .......................................26
Lighting Instructions .... Back Cover
Unpacking the Fireplace
1. Before you remove the carton, remove the cast
iron parts that are packed around the fireplace
cabinet.
PLEASE READ THESE INSTRUCTIONS IN
THEIR ENTIRETY AND MAKE THEM
AVAILABLE TO ANYONE USING OR
SERVICING THIS APPLIANCE.
2. Lift the shipping carton off of the fireplace
cabinet.
3. Unpack the Firebox. The Logset is packaged inside
the firebox. Remove the Glass Panel Frame to
unpack the firebox:
• Locate the right and left spring latches on the
underside of the firebox floor. Release each latch
by pulling them forward to disengage the frame
body.
• Pull the Glass Frame away from the firebox and
lift to disengage it from the three steel tabs
located at the top of the firebox. Set the glass out
of the way.
Do not unpack the logs until you are ready to
install them.
Pull each Spring Latch to disengage them from the
Glass Frame.
Spring Latch