Filter
Top Products
7
RECEIVER CHANNEL SELECTION
The receiver system can monitor up to 2 wireless
cameras. You can operate the receiver in either
Manual or Auto mode. To view more than one
camera, locate the camera channel selection
switch (1 2 1/2) on the rear panel of the
receiver.
The receiver must be set to the ‘1/2’ position to
allow two cameras to be monitored. The next step
will be to set the channel selection switch on both
cameras. See Camera Channel Selection.
MANUAL MODE
Operating the receiver in
manual mode allows you
to manually select a single
camera/channel to monitor
exclusively. The system will
remain on the selected
channel indefinitely until the
other channel is selected. To select one of the two
channels (cameras) manually, locate the AUTO
and MANUAL buttons on the top of the receiver.
Press and release the MANUAL button. The red LED
labeled ‘A — M’ will turn on and the corresponding
Auto
Manual
Channel
Selection
switch