Filter
Top Products
20
Blank monitor
1. Make sure receiver or monitor is switched ON.
Ensure the correct video input on the TV/monitor
has been selected.
2. Make sure video cable is connected to TV/monitor.
Interference on camera picture
1. Make sure each camera (transmitter) is within
range, and that no large obstructions are blocking
the signal.
2. Try repositioning the camera, receiver or both
to different locations in order to improve the
reception quality.
3. If using two cameras, make sure the cameras are
not set to the same channel.
4. Reposition other nearby equipment transmitting
on the 900MHz frequency.
5. Adjust the antenna for the camera, receiver or
both to obtain best image.
The image is upside down
You may have to rotate the camera housing. Loosen
the hex head nut and rotate housing so that the
channel selection switch is above the lens (see
page 17).
Audio problems
1. Ensure the volume is turned up sufficiently on the
Monitor (or TV).