Filter
Top Products
ILLUSTRATION 19
WASHER (1)
SCREWS (2)
SCREW INTO
FIXED PANEL
Y
W
X
SCREW(1)
SCREW HERE
EXTERNAL TOOTH
LOCK-WASHER #8
STAINLESS STEEL
WASHER
QTY.-1
Y
BOLT
QTY.-2
W
SHEET METAL
SCREW
#8-18X 2" S.S.
SCREW
QTY.-1
X
RING TO TOWER
SCREW, HEX
WASHER BOLT
1/4-20X2.5"
ILLUSTRATION 16
BRACKET LOCATING
PARALLEL
WITH
STUD WALL
FLAT PORTION
OF TOP RING
FLAT WASHER
TYPE A
STAINLESS STEEL
WASHER
QTY.-3
U
WOOD SCREW
SCREW
QTY.-3
V
ILLUSTRATION 17
TOWER
WALL
TOP PLANE
OF RING
MARK LINE
TOP RING
RING TOP PLANE MARK
STUD WALL
WALL
BRACKET
ILLUSTRATION 18
BRACKET TO WALL
TOWER WALL
WALL BRACKET
SCREW (3)
MARK LINE
WASHERS(3)
V
W
INNER SURFACE OF
BRACKET UPPER LEG
RING
LOCATED IN HARDWARE PACK
15
12.Locate the top ring. Remove the plastic retainer extrusion and set
it aside for later use. Place the top ring on the fixed panel and
tower wall. The top ring groove on the underside of the top ring
must mate with the top of the fixed panel. The flat portion of the
ring should be parallel with the stud wall. (See Illustration 16.)
Mark a line on the stud wall indicating the top plane of the bracket.
(See Illustration 17.) Remove the ring. The top surface of the
bracket upper leg must align with the top ring line previously
marked. (See Illustration 18.) Locate and secure the bracket to
the wall.
13.Place the top ring on the tower and fixed panel. Align the three
holes in the top ring with the two tower holes and one hole in the
fixed panel. (See Illustration 19.) Secure the top ring to the tower.