Filter
Top Products
14
FIXED PANEL ASSEMBLE TO BATH
11. Screw 1 1/2" Allen set screw 3/4" deep into the bottom of the fixed panel. Lay a 1/4" bead of sealant under
the bottom rail and inside the back channel of the vertical frame. Place the assembly against the vertical
edge of the tower and onto the bath surface, interlocking the two extrusions. (See Illustration 15.) Secure the
assembly to the bathtub using one (1) nut and washer and four (4) screws and washers following the fasten-
ing sequence. Gently push on the shaded portion of the bottom rail (see Illustration 15) to align with the holes
in the bath shell. After installing the fixed panel, apply sealant along all four inside edges of the glass frame.
Clean up excess sealant.
VERTICAL
EDGE OF
TOWER
1
FASTENING
SEQUENCE
ILLUSTRATION 15
HEX LOCKNUT
#8-32
T
NUT
QTY.-1
M4.2X19MM
STAINLESS STEEL
SCREW
QTY.-4
R
FLAT WASHER
#8 TYPE B
STAINLESS STEEL
WASHER
QTY.-5
P
SET SCREW
#8-32 x 1 1/2"
SCREW
QTY.-1
AA
(5)
P
(4)
R
AA
CAULK
2
3
4
5
LOCATED IN HARDWARE KIT
GENTLY PUSH
THIS AREA
T