Filter
Top Products
7
3-in-1 TV STAND
www.insigniaproducts.com
ASSEMBLY INSTRUCTIONS
Step 1: Align and attach the left and right side frames (A and B) to the
back frame (C)
Caution: Assemble your stand on a carpeted floor or the empty carton to avoid scratching your stand.
1 Insert two 1 3/8" bolts (U) through both lock washers (X) and flat washers (Y) through the drilled holes on the
left side frame (A) and screw into the threaded holes on the side of the short back frame (C).
2 Repeat the same procedure to attach the right side frame (B).
NOTE: Do not fully tighten all bolts until you finish assembling all parts. Once assembled, go back and fully tighten all
bolts. This will make the assembly easier.
UP
You’ll need:
U (4)
X (4)
Y (4)
EE (1)
NS-3IN1MT50C-NS-3IN1MT50C-C_14-0478_MAN_V2_ENG.fm Page 7 Wednesday, May 7, 2014 1:33 PM