Filter
Top Products
PD05P-XXX-XXX (en) Page 7 of 8
PARTS LIST / PD05P-XXX-XXX AIR MOTOR SECTION
) TORQUE REQUIREMENTS (
NOTE: DO NOT OVERTIGHTEN FASTENERS.
(134) Torque to 15 - 20 in. lbs (1.7 - 2.3 Nm), wait 10 minutes, then
re-torque to 15 - 20 in. lbs (1.7 - 2.3 Nm).
LUBRICATION / SEALANTS
c Apply Key-Lube to all “O” rings, “U” cups and mating parts.
Figure 4
MAJOR VALVE DISASSEMBLY
Remove (129) mu er and (130) gasket.
Pull (135) valve block assembly from (101) motor body.
Remove (134) bolts, (133) washers and (132) gasket from
(135) valve block.
Remove (141) valve plate and (140) valve insert.
Remove (136) plug and (111) spool.
1.
2.
3.
4.
5
.
MAJOR VALVE REASSEMBLY
Assemble new (138 and 139) “U” cups on (111) spool -
LIPS MUST FACE EACH OTHER.
Insert (111) spool into (135) valve block.
Assemble (137) “O” ring on (106) plug and insert into (135)
valve block.
Assemble (140) valve insert and (141) valve plate to
(135) valve block. NOTE: Assemble (140) valve insert with
“dished” side toward (141) valve plate. Assemble (141)
valve plate with 2 identi cation dots toward (132) gasket.
Assemble (132) gasket, (135) valve block and (129) muf-
fler assembly to (101) motor body, securing with (134)
bolts. NOTE: Tighten (134) bolts to 15 - 20 in. lbs (1.7 - 2.3
Nm).
1.
2.
3.
4.
5
.
132
129
118
142
119
120
141140
103101131
104143
130
122142
135
134
111
136
(optional) 201
(optional) 129
102
133
138
139
137
MAJOR VALVE
(see note 1, page 6)
PILOT VALVE