Infinity L30 Burner User Manual


 
SPECIFICATIONS
INFINITY M INFINITY L
Electrical
115V 60Hz 1150W
115V 60Hz 1610W
Capacity
8-1 3/4” rings or 2-3” rings
15-1 3/4” rings or
5-1 3/4” rings and 3-3” rings
Overall
Dimensions
10-3/4”W x 13-7/8”D x 18-3/4”H
(27.3cm x 35.2cm x 47.6cm)
14-1/2”W x 14-3/8”D x 18-3/4”H
(36.8cm x 36.5cm x 47.6cm)
Heating
Chamber
Dimensions
5-1/2”W x 5-1/4”D x 5-1/8”H
(14.0cm x 13.3cm x 13.0cm)
9-1/8”W x 5-1/4”D x 5-1/8”H
(23.2cm x 13.3cm x 13.0cm)
INFINITY M AND L
Number of Programs
30
NIGHT TIME
(DELAY START)
0 - 99 hours
Note: This is the time required for the program to be completed
and ready to cast.
HEAT RATE
*
(Stage 1)
a) 1 - 30°F/min. (1 - 17°C/min.)
b) “FULL” Stage heats at the maximum rate attainable.
HEAT RATE
*
(Stages 2, 3, & 4)
a) 1 - 30°F/min. (1 - 17°C/min.)
b) “FULL” Stage heats at the maximum rate attainable.
c) “NO” Stage is not used.
d) “COOL” Stage cools down to the programmed temperature.
Note: If “NO” is selected for a stage, that stage and all subsequent
stages will not be used. The furnace, therefore, can be used for one,
two, three or four stage operation.
TEMPERATURE
a) Stage 1: 150°F - 2012°F (66°C - 1100°C)
b) Stage 2, 3, 4: 100°F - 2012°F (38°C - 1100°C)
HOLD TIME
0 - 4 hours
*
Programmable heat rates. Actual heat rate at high temperatures may be lower depending upon
furnace load and electrical voltage.
3
ENVIRONMENTAL CONDITIONS
- Indoor use
- Altitude up to 2000 m
- Temperature 5°C to 40°C (41°F to 104°F)
- Maximum relative humidity 80% for temperatures up to 31°C (88°F) decreasing linearly to 50% relative
humidity at 40°C (104°F)
- Mains supply voltage fluctuations not to exceed +/- 10% of the nominal voltage
- Pollution Degree 2, Installation Category II