Filter
Top Products
[8]
44805 10/23/2008
[a]
[b]
HALOGEN LIGHTS
1. Each light has its own switch [a].
2. Push once to turn the lamp on. Push
again to turn the light off.
3. 150 watt Bulbs are included.
• To replace bulbs.:
i. Unplug unit and make sure lights
cool down.
ii. Remove the wing nut [b] at the
top of the back of the light.
iii. Carefully let the cover hinge
down so as not to break the
lens.
iv. Re-lamp with Type T-3 150 watt
bulb or smalller.
v. Reverse instructions to close
unit.
CARRYING A LOAD
1. The power plug must be removed
from the power socket when carrying
a load.
2. Always carry a load with the fan
assembly locked in the lowest
position (load carrying position).
3. This unit has been tested to carry a
maximum capacity of 200 lbs.
4. For taller loads, the fan can be tilted
90 or 180 degrees to reduce load
interference with the fan.
FAN SPEED
1. Use speed control rotary knob to
control the fans 3 speeds: High,
Medium, and Low.
OPERATION
ENGLISH
WARNING
Always hold the top handle when
adjusting light direction due to
heat generated from light.