Filter
Top Products
17
INSTALLING THE THERMOSTAT, CONT.
CONNECTING THE WIRES
1. Loosen, but do not remove, the terminal
screws.
Note: A jumper wire has been provided, connecting the RC
and RH terminals for systems that do not provide both an RH
and RC wire. If you have both an RH and RC wire, remove this
jumper. If you do not have both an RH and RC wire, leave the
jumper in place.
2. Match and connect the wires from the wall to the terminals
as shown. Wires should be inserted behind the black terminal
shields. Tighten each screw after the connection has been
made.
(The ends of any extra wires should be individually wrapped in electrical
tape and carefully pushed back into the wall.)
3. Push any excess wire length back into the wall to prevent
interference.
G RC RH Y W
Jumper