Filter
Top Products
8
9
Mount Wallplate
• Remove the wallplate from the thermostat by pressing the release tab on the bottom of the thermostat.
See Figure 2.
Figure 2
• Position wallplate on wall and pull existing wires through the large opening, then level for appearance. If
the existing mounting holes from the old wallplate line up with the slots in the new wallplate, then use the
exisitng holes. If the exisitng holes do not line up with the slots in your new wallplate, then mark the wall
for holes for the provided plastic anchors.
• Drill holes with 3/16” bit and gently tap anchors into the holes until ush with wall.
• Reposition wallplate, pulling wires through large opening. Insert provided mounting screws into wall
anchor and tighten. See Figure 3.
Figure 3
Release Tab