Filter
Top Products
16
42693-01 • 11/11/09 • Hunter Fan Company
8 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Uninstalling the Light Fixture
8-14. To uninstall the light xture, rst disconnect the plug connectors
between the black wire and the red wire.
8-15. Disconnect the plug connectors between the two white wires.
8-16. Remove the two screws attaching the light kit to the lower
switch housing.
8-17. Remove the light xture from the lower switch housing, pulling
disconnected wires through the hole in the center of the lower
switch housing.
Note: When removing the wires, pull the thin plug connector
(male) through rst, and then pull the other plug connector
(female) through the hole.
8-18. Install the dummy terminals (included in the sack parts) on the
two disconnected wires in the lower switch housing.
8-19. Install the switch housing cap and plug button to the lower
switch housing.
8-20. Once you have uninstalled the light xture, continue
with step 8-6.
Male Dummy
Terminal
Female Dummy
Terminal
Step 8-19
Cap
Plug Button
Step 8-16
Lower Switch
Housing
Screw