Filter
Top Products
6
44064-01 • 05/06/2010
Using Your Humidifier
Controls
2
Operation:
See Figure 6.
Humidity Control:
The humidity control allows you to set the amount of humidity you want
the unit to output. The humidity knob is a percentage, ranging from
30% at its lowest to 80% at the highest. Turn the knob clockwise to
increase humidity output. When the humidier has reached the set
humidity level, it will shut off until the humidity level drops again. To turn
the unit off, turn the the humidity knob past the lowest setting to off.
Indicators:
UVC Indicator: When the UVC indicator lights up, it is time to replace the UVC
Bulb in the bottom of the unit. Replacing the bulb will reset the indicator.
Demineral Indicator: When the demineral indicator lights up, it is time to replace
the demineralization cartridge in the base of the unit, if you are using one. Remove
the tank from the unit, and the demineralization cartridge should be sitting inside
the water tray in the bottom. Hold the reset button down under the indicator for a
few seconds until the light goes out to reset.
Rell Tank Indicator: This indicates the tank is out of water. Once you have relled
the tank with water and set it back onto the unit, the rell tank light will reset.
Rell Tank
Demineral
UVC
O
Figure 6